beko d/w

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › beko d/w

Viewing 6 posts - 1 through 6 (of 6 total)
  • Author
    Posts
  • October 23, 2008 at 3:41 pm #40438
    petalpop
    Participant

    have a call tomorrow to a beko D/W model dwd5410w with no heat
    will it be the flow-thru element as i have looked up spares on connect and they don`t show any stats so presume it has them on the element
    if there are stats where are they + any part numbers would be good
    cheers

    October 23, 2008 at 9:29 pm #266337
    petalpop
    Participant

    Re: beko d/w

    anybody please

    October 30, 2010 at 6:37 pm #266338
    Simon46
    Participant

    Re: beko d/w

    Ive got one to do next week. What was the fault on yours?

    S.

    October 31, 2010 at 4:06 pm #266339
    petalpop
    Participant

    Re: beko d/w

    i can`t for the life of me remember
    it wasn`t the element though
    i think the wires to the element had burnt so cut back and refitted

    October 31, 2010 at 5:10 pm #266340
    A1engineer
    Participant

    Re: beko d/w

    pcb’s are bad on these, make sure you get serial etc as there are loads, i think they get stuck on prewash hense no heat!!

    November 16, 2010 at 8:07 pm #266341
    Simon46
    Participant

    Re: beko d/w

    Fitted new PCB was different :rolls: Only drains no fill. Luckily PCB only had dry jointed 12V relay so fitted Maplins relay. Sorted. Many thanks.

    S.

  • Author
    Posts
Viewing 6 posts - 1 through 6 (of 6 total)
  • You must be logged in to reply to this topic.