F&P error wont pump suspect controller

Home › Forums › Public Support Forums › International Forums › Australasian Appliance Forum › F&P error wont pump suspect controller

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • October 29, 2008 at 3:38 am #40591
    tones
    Participant

    Greetings,

    I am trying to repair a F&P GW609 that has an intermittant fault of stopping at rinse cycle. Pump works fine when used in service mode, so suspect controller. Fault listed on display panel is 01101011 can anyone help?

    Thanks in advance

    Tony

    November 4, 2008 at 1:00 am #266937
    Penguin45
    Participant

    Re: F&P error wont pump suspect controller

    Tech describes that one as a motor controller crash – you’ll need to source a replacement.

    Penguin45.

    November 4, 2008 at 8:45 pm #266938
    tones
    Participant

    Re: F&P error wont pump suspect controller

    K….thanks kindly for your help. It is what I suspected but was not 100{e5d1b7155a01ef1f3b9c9968eaba33524ee81600d00d4be2b4d93ac2e58cec2d} sure as did not have a diagnosis chart of diag codes.

    Will try new module.Thanks again for your time

    Tony

    November 5, 2008 at 1:33 am #266939
    bigsmokepiker
    Moderator

    Re: F&P error wont pump suspect controller

    Still double check pump
    Pumps can overheat and go out on overload
    When pump cools Down it will then run
    Just chaek that pumps not geeting to hot

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.