- This topic has 4 replies, 3 voices, and was last updated 17 years, 5 months ago by
.
-
Posts
-
Machine will be set to Quick Wash only. It fills up, then goes into a pre-spin mode, then tries to spin with a full load and water. This results in violent shaking and water being forced up the overflow. It will then empty. The light sequence starts at the Wash, it skips the Rinse and goes straight to Spin, all while still fully loaded. Have gone through the sequences several times to make sure it starts correctly. I have looked through some of your pages for advice, and then looked for obvious defects with the PCBs but cannot see any ‘burns’ . Help please
Re: Servis Easi Logic 1500 running out of sequence.
Hi
Correct model number please , it will be M**** And serial number will help with diagnosis.
Mike
Alun wrote:Sorry,
Model M9150.
S/n. 20034502534-014077063-01 02
Thanks Alun.Mike or anyone who can help with this please,
I have more examples of the problem I posted earlier, I have also priced a replacement PCB if that is what it turns out to be, but I dont want to proceed with that until I’m advised.
AlunRe: Servis Easi Logic 1500 running out of sequence.
It sounds like a PCB which, given it’s a Servis, isn’t exactly a shock. 😉
However there’s only one way to know for sure, replace it and see what happens.
It could, I guess, be something else but there’s about an 85-90{e5d1b7155a01ef1f3b9c9968eaba33524ee81600d00d4be2b4d93ac2e58cec2d} probability that it’s the module. There is no way to be 100{e5d1b7155a01ef1f3b9c9968eaba33524ee81600d00d4be2b4d93ac2e58cec2d} sure of it I’m afraid beyond replacement.
Let me put it this way, I’d be surprised if the module wasn’t the problem.
HTH
K.
- You must be logged in to reply to this topic.