Hoover HNF 6127-80 NO GO

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Hoover HNF 6127-80 NO GO

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • November 5, 2008 at 3:00 pm #40779
    Latham63
    Participant

    Initial fault was a burnt out main module board.This was replaced along with button cluster module and burnt connections.
    Door interlock also replaced.
    Motor and heater check out ok
    Upon selecting prog,door locks,selected prog illuminates,then nothing?
    Both Start and Delay Start lights flash 5 times stop then repeat flashing?
    Me baffled

    November 5, 2008 at 3:39 pm #267525
    wilf
    Participant

    Re: Hoover HNF 6127-80 NO GO

    is the board configured? apparantly some are and some are not. it caught me out a while back, dont know how you tell one part from the other as an old mate from candy gave me the info and had a second hand board that got me out of the nasty stuff!
    check with hoover

    wilf

  • Author
    Posts
Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.