Rosieres Range Cooker 4040DB

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Rosieres Range Cooker 4040DB

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • November 6, 2008 at 9:12 am #40800
    roly16
    Participant

    Does anybody know how to access the inner hinge runners, ie. the left hand one of the right oven and the right-hand one of the left oven? I presume the outer ones are easily accessible from the side panels.

    Thanks

    Geoff

    November 6, 2008 at 9:59 am #267599
    admin
    Keymaster

    Re: Rosieres Range Cooker 4040DB

    Hi Geoff.

    You’ll need the following:A Long length of capillary & heavy 12″ chisel.

    Take both drawers out,undo all the screws out the old hinge receivers and they will drop down.Along the centre below the drawer runners there are holes approx 4″ dia,gently but forcefully bend the hole a bit to allow the new hinge receiver to slip through but dont put it in yet.
    Put the cappilary though the front hinge hole and pull it through the widened hole at the bottom and make a hook on the end.put the hook through the new hinge and slowly pull it up through the centre into place.you can then refit the screws.

    Takes me about 25mins to do full set of 4 without the cooker being moved.but ive done piles of them.Give me a call if you need clarification Geoff.

    Bryan

    November 6, 2008 at 10:23 am #267600
    roly16
    Participant

    Re: Rosieres Range Cooker 4040DB

    Thanks for that Bryan. If you don’t move the cooker, how do do the outer ones? Is it the same way, from underneath?

    November 6, 2008 at 11:03 am #267601
    admin
    Keymaster

    Re: Rosieres Range Cooker 4040DB

    Hi Geoff

    Yep same way for the outer ones as well…Lot easier and No weight to move.

    Bryan

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.