servis m2905 no fill

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › servis m2905 no fill

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • November 11, 2008 at 4:20 pm #40950
    machineman
    Participant

    Tested valves – good, tested presuure switch – good put it on to filll and drum just goes round with 2 lives being fed to both valves.

    I’m thinking board any1 else had this problem?

    November 11, 2008 at 4:44 pm #268170
    jess1ca
    Participant

    Definitly PCB had a lot of these no fill fault Dave

    November 11, 2008 at 5:02 pm #268171
    robbra
    Participant

    Re: servis m2905 no fill

    No such model that I know of, driers start with M2
    What’s the serial no?
    Rob

    November 11, 2008 at 5:47 pm #268172
    machineman
    Participant

    sorry m3905 ser 20023804526

    November 11, 2008 at 6:04 pm #268173
    robbra
    Participant

    Re: servis m2905 no fill

    Hi MM,
    sounds like the module but on some if you select one click past programme on dial it will do just as you say. Used to get lots like it but if you are one click before prog will add about 3/4 hour to the wash.
    Rob.
    Let us know what happens

  • Author
    Posts
Viewing 5 posts - 1 through 5 (of 5 total)
  • You must be logged in to reply to this topic.