diplomat range

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › diplomat range

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • November 14, 2008 at 11:10 am #41028
    superspin
    Participant

    hi all

    going to this range cooker next week to replace the main oven selecter switch, can anyone advise on the best way to access the switch it has a gas hob.


    heres the numbers mod 050564164 sn/30124078 also ADP5820

    thanks wayne.

    November 15, 2008 at 9:39 pm #268550
    mendy
    Participant

    Re: diplomat range

    Hi wayne, it will be a bit involved.Take off control knobs,then control panel.slide out the centre hob dividing piece.Go to the sides and take out the plastic plugs, 4 in total.The 2 hob tops should now be released.If a new one,these may also be screwed down.gently lift the hob tops and all is revealed.Take the screws out the phial plate right rear.Undo the screws for the relevant back plate so the rear is open for you to see access to the hole where the phial enters the oven cavity.Pull off phial from inside the oven so its free.Pull through ,unscrew the stat,fit all wires to new one and reverse all actions.Hey presto,another hour gone out of your life.Hope all goes well, all the best.

    November 18, 2008 at 7:47 pm #268551
    goosegreen
    Participant

    Re: diplomat range

    Sorry for hijacking this thread but last job today was for a Diplomat APL 5751 Range cooker. Model not listed on Masterpart but after a control for the griddle, It feels like a capillary stat rather than an Eng reg, And thanks to Mendy in advance for advise on how to access if I get the job.

    Goose

    November 21, 2008 at 10:27 pm #268552
    superspin
    Participant

    Re: diplomat range

    hi mendy

    thanks for that

    will be going to the job on tuesday, that will save me some head scratching 💡

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.