- This topic has 6 replies, 5 voices, and was last updated 17 years, 4 months ago by
.
-
Posts
-
S4453N2GB/01
seems to function ok but the times are upset.pre rinse 18 mins
quick wash 30 minsother three washes all say 199 mins remaining
i have resoldered a couple of dry joints on the board, and checked that the progaming code is correct (27).
am i missing something obvious or is it simply a module fault!Re: Neff d/w 199 mins remaining
bzz67 wrote:pre rinse 18 mins
quick wash 30 minsother three washes all say 199 mins remaining
The times stated for prerinse and quick wash are fine. The other programme times should default start at 120 mins I believe? They are usually dependent on a reading from the turbidity sensor once a programme gets under way. 😕
Re: Neff d/w 199 mins remaining
I have come across this problem after fitting a new heater. I was convinced that there couldn’t be two faults on the machine, and that I hadn’t done anything daft. Happy that the machine was doing all it should, bar the times it was showing, I told the customer to use it and see what happened, I didn’t have the time to stand for two hours watching it. She phoned me a couple of days later to say that it had dropped back into sync once she started using it. Was I lucky? Maybe, but it’s worth a try if you haven’t already. Steve
When the elements go open circuit the dishwasher runs for hours so the next time you use the appliance after replacing the element it estimates the time based on the last programme.
Re: Neff d/w 199 mins remaining
as boselecta said, they have fuzzy logic and work out how long it is going to take based on how long the last wash took. oh the wonders of modern technology 😆
- You must be logged in to reply to this topic.