Miele T5213

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Miele T5213

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • November 27, 2008 at 5:49 pm #41387
    geoff1
    Participant

    Hi

    Anyone help with this dryer.

    All is working except for heat. Checked all stats including exhaust stat which are ok. element ok.

    Any ideas? wiring diagram would be useful if anyone has one

    Many thanks

    Geoff

    November 28, 2008 at 6:01 am #269966
    bigsmokepiker
    Moderator

    Re: Miele T5213

    Wiring diagram usually tucked down the Bottom inside the Front panel
    It Will be there somewhere

    November 28, 2008 at 8:17 am #269967
    geoff1
    Participant

    Re: Miele T5213

    Hi

    No not even the plastic pouch it normally sits in on the panel is there.

    Suspect someone has been there before me.

    Geoff

    November 28, 2008 at 8:33 am #269968
    Seamy
    Participant

    Re: Miele T5213

    Is it the commercial one with heater assembly down on left hand side? If so there are cut-outs on top of heater which sometimes need to be re-set. Relay can also be a problem with them. If appliance wired to run on 240v check links on supply terminals as heating system on some had three separate circuits & if one phase was missing they wouldn’t heat.

    November 28, 2008 at 3:40 pm #269969
    geoff1
    Participant

    Re: Miele T5213

    Hi

    Yes it is the commercial one with the heater on left hand side.Have checked all 4 ( 3 are resetable) and the one fitted to the duct on the front.

    Wired to 240volt but looks to me as if the 3 heaters are wired in paralell from the relay.

    You could be right about relay or what controls it as it appears not to activate.

    Again thank you for your advice and help

    Geoff

  • Author
    Posts
Viewing 5 posts - 1 through 5 (of 5 total)
  • You must be logged in to reply to this topic.