Bosch condenser dryer (wte84102GB)

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Bosch condenser dryer (wte84102GB)

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • December 4, 2008 at 2:56 pm #41582
    conormccleane
    Participant

    Hi.
    Fault report – stops heating on sensor drying program after a short time (few minutes)
    Fault history – heat exchanger was clogged with fluff – cleaned & testing OK on timed drying program 5 days previous.
    Large pool of water on floor around/under appliance.
    How do I remove the drum to expose plumbing? (thru’ top/back/sides?). Help most appreciated.
    Thanks,
    Conor!

    December 4, 2008 at 3:26 pm #270671
    Martin
    Participant

    Re: Bosch condenser dryer (wte84102GB)

    Sounds like the pump hose to water container are blocked? Usually at the nozzle on top of the water container. 😉

    Also clean out the fluff deposits behind the condenser matrix and flush with water a few times. Otherwise it will block again in pretty short order! :rolls:

    December 4, 2008 at 4:05 pm #270672
    conormccleane
    Participant

    Re: Bosch condenser dryer (wte84102GB)

    Thanks Dave,
    Have left side off and exposed condensate pump – float switch and pump covered with crud – have cleaned and replaced. Condensate and breather pipes are clear. Is there anything else I should look at before I reassemble machine?
    Thanks, Conor!

    December 4, 2008 at 5:00 pm #270673
    Martin
    Participant

    Re: Bosch condenser dryer (wte84102GB)

    Pour (say) a pint of water into the back (behind) of the condenser matrix, switch on and see if that water pumps straight up and into the water container?

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.