Bosch SGS5358GB/17 D/W

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Bosch SGS5358GB/17 D/W

Viewing 6 posts - 1 through 6 (of 6 total)
  • Author
    Posts
  • December 6, 2008 at 10:34 am #41631
    rocker
    Participant

    Finishing 60min cycle in 35mins also water left in base when finished.
    any ideas what may cause this fault, is it the PCB !!
    Cheers John.

    December 6, 2008 at 10:38 am #270790
    cornwell40
    Participant

    Re: Bosch SGS5358GB/17 D/W

    Had the same fault symptoms this week. Water in base due to motor/ circ pump noisy for a while, seal gone and leaking badly. Motor was begining to cook itself and prog stopped at 30 mins. Its a possibility 😉 .

    TC

    December 6, 2008 at 10:48 am #270791
    Martin
    Participant

    Re: Bosch SGS5358GB/17 D/W

    rocker wrote:is it the PCB !!

    Nah!…PCB’s dont leak water!!! 😉

    First thing to check is the water inlet matrix, pressure switch unit and sump transfer pipe? If they’re gunged up (and they usually are) then water spills over the top and onto the base. 😯

    HTH?

    December 6, 2008 at 3:13 pm #270792
    rocker
    Participant

    Re: Bosch SGS5358GB/17 D/W

    Sorry gents mislead you somewhat, when I said water in base, I meant in side the machine, ie not pumped out. not in lower base.
    cheers John

    December 7, 2008 at 7:53 am #270793
    Martin
    Participant

    Re: Bosch SGS5358GB/17 D/W

    rocker wrote:ie not pumped out.

    Drain pump blocked/jammed? 😕

    December 7, 2008 at 1:16 pm #270794
    rocker
    Participant

    Re: Bosch SGS5358GB/17 D/W

    Thanks Martin for advice, will check this out tomorrow. John.

  • Author
    Posts
Viewing 6 posts - 1 through 6 (of 6 total)
  • You must be logged in to reply to this topic.