Hotpoint WD860 no dryer

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Hotpoint WD860 no dryer

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • December 15, 2008 at 9:12 am #41864
    iadom
    Moderator

    Set to drying cycle, machine runs perfectly except for no heat/live feed to dryer.
    Customer reports no error messages at all.

    Had a complete heater box assy fitted in Feb and everything on it appeared to check out fine.

    Bunged in the hardware key and within a minute got an F13. tightened up the tiny, pathetic plug to the NTC and this time it ran through TEST until dryer heater should have kicked in and threw up F14.

    All components and wiring appear perfect, I’m guessing main PCB is at fault, unless you know better. 😉

    Console display is also flickering badly. 😥

    Jim.

    December 15, 2008 at 6:05 pm #271589
    iadom
    Moderator

    Re: Hotpoint WD860 no dryer

    So, we are all agreed then, duff PCB. ❓ 🙂

    December 15, 2008 at 6:56 pm #271590
    johnnyj
    Participant

    Re: Hotpoint WD860 no dryer

    If everything else checks out i’d guess a duff module Jim, F14 no heat to dryer, flickering display will need a new console module, there was a resistor changed on these to cure .

    December 15, 2008 at 6:58 pm #271591
    iadom
    Moderator

    Re: Hotpoint WD860 no dryer

    Cheers Jonny, I’ll give her the good news. 😥

    Jim.

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.