F&P GW700 Washer

Home › Forums › Public Support Forums › International Forums › Australasian Appliance Forum › F&P GW700 Washer

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • December 28, 2008 at 1:56 am #42114
    bill2t
    Participant

    Hi

    We have a F&P GW700BF washer stopping on water fill. Diagnostic code is 30 . Solenoids and pump can be started ok. Cleaned muck from pump.

    Any suggestions ???

    Thanks

    bill

    December 28, 2008 at 4:48 pm #272439
    Penguin45
    Participant

    Re: F&P GW700 Washer

    Display board and motor controller board are not talking to each other properly. Pulling the plug briefly may restore order or reveal a new code.

    Penguin45.

  • Author
    Posts
Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.