- This topic has 4 replies, 3 voices, and was last updated 17 years, 2 months ago by
.
-
Posts
-
T234c condenser (in very cold garage) Heater has now got traces of condensation and is reading to earth.
Called out to this one with the relay/contactor burnt out, replaced it only used once and now its burnt out again.
Any ideas? Could it be that the condensation has shorted the element, causing the problem?
Steven
Re: Miele Tumble dryer
cold be worth checking that the condenser fan is working correctly… some of these are under the machine
Re: Miele Tumble dryer
you have not said how this contactor has failed
if the heater had shorted i would expect it to blow the fuse and maybe weld the contactor contacts together
if as you describe this is a burn out unless moisture is getting inside vthe contactor than this can only bad electrical connections. cut the wires back far enough to find clean wire and replace with new good quality connectors that are tight any loose conns will get hot and burn out
hope this helps
Dave
Re: Miele Tumble dryer
Yes Sorry
The Relay contacts welded, very strange as c/x said only used once?
Did not blow fuse. just tumble no heat.
Steven
- You must be logged in to reply to this topic.