diplomat dishwasher adp8101 water staying cold

Home › Forums › Public Support Forums › Help And Support › Dishwasher Help Forum › diplomat dishwasher adp8101 water staying cold

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • January 27, 2009 at 4:05 pm #42931
    wales
    Participant

    i have just replaced the lower spray arm on this machine and had to stop it in mid program as the machine was leaking. On fitting the new arm the machine starts up and runs but the water is cold and the programme runs continously and will not finnish any suggestions would be appreciated

    January 27, 2009 at 7:04 pm #275412
    martinm
    Participant

    Re: diplomat dishwasher adp8101 water staying cold

    there is a thermostat reset button on these which is probably the cause. If you remove the right hand side panel you will see the red button on thermostat at bottom of dishwasher, I must emphasise make 100 percent sure that the dishwasher is unplugged/disconnected first.

    February 1, 2009 at 11:54 am #275413
    wales
    Participant

    Re: diplomat dishwasher adp8101 water staying cold

    thanks for the tip i have just removed the side and found the button, it was sitting up and it i cant push the button down, do you suggest a new thermostat button?

    thanks kevin

    February 1, 2009 at 1:23 pm #275414
    Penguin45
    Participant

    Re: diplomat dishwasher adp8101 water staying cold

    Test meter time………. Check for continuity through the re-set thermostat; resistance should be virtually zero. Split component from circuit to avoid back-reading. Meter heater for resistance – 25-30 ohms is usually about right.

    Broken wiring in the door at the pivot point was quite a regular problem with these.

    Stay safe, power off if you are planning to do this yourself.

    Penguin45.

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.