hotpoint wt 741

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › hotpoint wt 741

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • January 28, 2009 at 11:44 am #42951
    wilf
    Participant

    customer reports that machine got half way through then stopped with “door” showing in the display. it did this a couple of times so the customer changed the interlock but the fault persisted.
    I checked it out sump heater connections etc and it ran through two rinses ok so I left now its stopped with seven minuits to run customer cleared the program to start again and it is now dead. Im thinking board
    Any ideas?

    wilf

    January 28, 2009 at 4:24 pm #275475
    helo_75
    Participant

    possibly, but id check the heater first

    ALWAYS a good place to start with these babies

    January 28, 2009 at 4:55 pm #275476
    wilf
    Participant

    Re: hotpoint wt 741

    heater test ok continuity and insulation.

    wilf

    January 28, 2009 at 5:45 pm #275477
    helo_75
    Participant

    then its the board

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.