Whirlpool AWO/D 4605

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Whirlpool AWO/D 4605

Viewing 12 posts - 1 through 12 (of 12 total)
  • Author
    Posts
  • January 29, 2009 at 4:17 pm #42991
    Taff
    Participant

    When any program is selected the service light comes on and the start/pause light flashes. Tried switching on and off and reset buttons with little success. Seems to be stuck in mid program. Any assistance would be appreciated.
    Regards

    Taff

    January 29, 2009 at 5:03 pm #275605
    Martin
    Participant

    Re: Whirlpool AWO/D 4605

    2 thoughts?….Blocked air bell or, more likely, motor brushes. 😉

    January 29, 2009 at 6:21 pm #275606
    Taff
    Participant

    Re: Whirlpool AWO/D 4605

    Tried both these. I will try a new door switch, but these don’t come cheap.

    January 30, 2009 at 9:59 am #275607
    electrofix
    Moderator

    Re: Whirlpool AWO/D 4605

    if it is the same as awod 4505 have got one i can send you out of scrapper also complete front panel not sure if it is the same

    Dave

    January 30, 2009 at 10:03 am #275608
    electrofix
    Moderator

    Re: Whirlpool AWO/D 4605

    if it was me my next move would be to check for L+N on the door lock or power door lock up seperatly to check operation you can find right terms with multimeter if it is a heater type

    also find the live and switch wire to the machine and short out to see if it bursts into life

    hope this helps

    Dave

    January 30, 2009 at 10:36 am #275609
    tash
    Participant

    Re: Whirlpool AWO/D 4605

    i had same prob before xmas..new door switch put it right…although like you said expensive for switch 🙂

    February 1, 2009 at 2:02 pm #275610
    Taff
    Participant

    Re: Whirlpool AWO/D 4605

    Dear Dave, I would appreciate a door switch as electrue are currently out of stock. If you can send me one please drop a note in with the switch to let me how much cash to send.

    Regards

    Taff

    February 1, 2009 at 11:49 pm #275611
    electrofix
    Moderator

    Re: Whirlpool AWO/D 4605

    pm me your address will check in morn and post tomorrow


    Dave

    February 2, 2009 at 12:55 am #275612
    leavemetogetonwithit
    Participant

    Re: Whirlpool AWO/D 4605

    With any door switch like that with three tags, as long as you can figure out which terminal is which, you can just use extension test leads (spade one end, receptacle t’other) to link it up to a cheap Hotpoint red plastic lock and try it.
    Mike.

    February 2, 2009 at 9:23 am #275613
    Taff
    Participant

    Re: Whirlpool AWO/D 4605

    Thanks Dave

    Address is K Chedzoy, Ortgeard,Dishforth, Thirsk,YO7 3LP.

    Your help is much appreciated.

    February 2, 2009 at 10:38 am #275614
    electrofix
    Moderator

    Re: Whirlpool AWO/D 4605

    posted post cost 52p

    should be with you soon get the snow ploughs out

    Dave

    February 6, 2009 at 1:12 pm #275615
    Taff
    Participant

    Re: Whirlpool AWO/D 4605

    Thanks Dave got the switch. Same fault occurs. Letter with cash on its way. What board is fitted to the scrapper. The part numbers on this board are 4619 714 14743 Type C1 and 461975307543. Any chance they are the same?

    Regards

    Taff

  • Author
    Posts
Viewing 12 posts - 1 through 12 (of 12 total)
  • You must be logged in to reply to this topic.