- This topic has 4 replies, 2 voices, and was last updated 17 years, 2 months ago by
.
-
Posts
-
Earth fault when tested from plug top, I removed the plug from the
mains suppressor & tested again fault clear.
I then tested from suppressor plug NO fault the only time you get
a fault is when the suppressor plug is re-connected,I tried a new suppressor unit and tested heaters,fan,nct,pump,motor,black motor
lead cut out and looms.
Roycut the plug off about 3 inches from the end and youll find itll be ok with a new plug on
seen it a few times
Re: Hotpoint WD860 3 phase control trips RCD
The machine does not have a moulded plug,I checked the plug connections all ok, also the fault would not go away if you unplug
the mains suppressor thanks for any help.
Roystrange one that
i had one just the other week, and changin the lead and supressor complete and it cured it
those machines are pants
Re: Hotpoint WD860 3 phase control trips RCD
I was sure it was the supressor, but still faulty.
Called Tony at EMW he thought it was the main board as the fault
only showed up when the suppressor plug is in, another scrap machine ,
fitted a new display board two months ago and that was the
second one thanks for the help
Roy.
- You must be logged in to reply to this topic.