- This topic has 1 reply, 2 voices, and was last updated 17 years, 2 months ago by
.
-
Posts
-
After reading many posts about my initial problem, I have done all the neccessary bits and now have a completely different issue.
At first I had the 4 flashes and beeps pointing to draining issue which by all accounts was 100{e5d1b7155a01ef1f3b9c9968eaba33524ee81600d00d4be2b4d93ac2e58cec2d} correct as it filled, done a partial wash then failed.
I cleaned the NTC, the ‘black bit’, and removed and cleaned the pump. I suspect the pump had failed, because there was no whiring or blockage.No my issue is that the pump stays on regardless of whether I t is set to wash or not! It no longer attempts to wash just goes to run the drainage pump.
Any ideas?
Re: Help with Whirlpool ADG7450
Normally, this would be considered a flood protection issue, but you machine does not seem to have the float mechanism fitted.
Secondly, if the machine faults, it will run the drain pump whilst flashing the start lamp in a pattern, ie 1-2-3-4-pause-repeat. You can clear it by pressing and holding the start button until it stops.
If the drain pump runs regardless of either of the above, there will be a fault on the pcb.
Penguin45.
- You must be logged in to reply to this topic.