Control Board for Hotpoint WMA 13 Washing Machine

Home › Forums › Public Support Forums › Spare Parts Help › Control Board for Hotpoint WMA 13 Washing Machine

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • February 7, 2009 at 9:15 pm #43260
    Springnuts
    Participant

    Hi,

    I would be grateful for advice about control boards. I need a control board for a Hotpoint WMA 13 Washing Machine. I have a board from a Creda W200FW Washing Machine.

    They look identical however have different numbers on them (Hotpoint first):

    AKO 547 101 HW01, GDA 1617205008, mask index 020

    AKO 547 203-00 HW01, GDA 1617206401, mask index 019

    I guess they aren’t interchangeable, but it would be nice if they were.

    I saw the v helpful post here http://www.ukwhitegoods.co.uk/modules.p … trol+board about checking for what caused the board to blow.

    Thanks in advance if you are able to cast any light on this.

    Regards

    Springnuts

    February 8, 2009 at 12:12 am #276657
    iadom
    Moderator

    Re: Control Board for Hotpoint WMA 13 Washing Machine

    Totally different PCB’s, they are not interchangeable. 😥

    If the board has blown then it will have been caused by a fault elsewhere.

    Jim.

    February 9, 2009 at 10:50 pm #276658
    Springnuts
    Participant

    Re: Control Board for Hotpoint WMA 13 Washing Machine

    Hi

    Thanks – and for the warning about problems elsewhere so I don’t just blow up the next one!

    Regards,

    Simon.

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.