CDA BI1200WD H/C

Home › Forums › Trade Technical & Spare Parts Forums › Trade Spare Parts › CDA BI1200WD H/C

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • February 23, 2009 at 3:37 pm #43685
    nelson
    Participant

    Hi fellas, I am trying get a sump hose for the above machine, however none of my usual suppliers can help me.
    I have never worked on a CDA machine before so please excuse my ignorance, I am not sure which of these numbers are relevant.
    LVO 192d01918
    78 08251 00 260500

    Thanks

    February 23, 2009 at 7:40 pm #278112
    Penguin45
    Participant

    Re: CDA BI1200WD H/C

    36192500 from Masterpart – £20 odd. It’s a Siltal, so tank out to fit.

    Chris.

    February 23, 2009 at 10:31 pm #278113
    nelson
    Participant

    Re: CDA BI1200WD H/C

    Cheers Chris 😀

    March 3, 2009 at 10:46 pm #278114
    whiskeyjack6058
    Participant

    Re: CDA BI1200WD H/C

    If its a typical Siltal washer dryer, I have done loads, rather than remove the tank, remove the heater, place a long thin wooden plank in to fill the gap the heater would. This way the gromet wont keep popping into the tub. Lay the machine over onto the dispenser side. apply washing up liquid to the inside of the sump hose so the inner gromet slips up easy. fit the sump hose into place and slip up the gromet till it clicks into place. This is a cow of a job and very dangerous to your fingers as the tub is RAZOR sharp! Sometimes I have had to order up a spare sump hose as i have ripped the first one fitting it causing a very frustrating leak!
    The soap dispensor hose is just as nasty!
    Good luck!
    Regards,
    Rob.

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.