Hotpoint wt960

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Hotpoint wt960

Viewing 6 posts - 1 through 6 (of 6 total)
  • Author
    Posts
  • February 24, 2009 at 6:45 pm #43723
    rickard
    Participant

    I went to look at a noisy wt960 today, I found that the front weight was loose this happened all of a sudden. Is it a common fault for this to come loose or is there a long term fix for this as i have just tightened the bolts up at the moment. Can i just walk away after tightening them up or are they going to come loose again.
    Andy

    February 24, 2009 at 6:51 pm #278298
    iadom
    Moderator

    Re: Hotpoint wt960

    Time will tell, it just depends how much damage has been done to the plastic mounts.

    The only long term fix is a new drum. 😥

    Jim.

    February 24, 2009 at 6:54 pm #278299
    rickard
    Participant

    Re: Hotpoint wt960

    Thanks Jim
    I was just wondering if there was a modification on the bolts or drum. Will warn customer if loose again then it will have to be new drum
    Andy

    February 24, 2009 at 6:58 pm #278300
    iadom
    Moderator

    Re: Hotpoint wt960

    There is a modification, its called an ISE 10 😉 😆

    Jim.

    February 24, 2009 at 7:55 pm #278301
    helo_75
    Participant

    or take off the weight, wrap tape around the plastic then refit the weight

    coarse,but serves its purpose

    February 25, 2009 at 6:40 pm #278302
    roy1
    Participant

    Re: Hotpoint wt960

    I allways take the weight off wrap tape around the plastic lugs
    untill the weight fits tight,and put some superglue on the bolts.
    Never had a problem after that.

  • Author
    Posts
Viewing 6 posts - 1 through 6 (of 6 total)
  • You must be logged in to reply to this topic.