- This topic has 6 replies, 4 voices, and was last updated 17 years, 1 month ago by
.
-
Posts
-
No error messages, heater, all wiring etc check out perfectly, module has no bad tracks or contacts. 😕
Completes programme every time.
Other than the usual module failure what else might it be?
Jim.
Re: Indesit WIXE127 no heat.
Martin wrote:I wonder what the NTC resistance shows?
(Trade Spares forum Jim?)
😳 DOH.NTC appeared to be OK, there is just no heat at all.
Jim.
Re: Indesit WIXE127 no heat.
Well then I guess it’s the Module otherwise if element or NTC went AWOL the module would start spouting out error messages, flashing lights and/or dial clicking? 🙁
Re: Indesit WIXE127 no heat.
Check for wire broken at spade terminal at heater – sometimes break inside insulation – give it a pull to see if it breaks – these machines sometimes go thru cycle without giving fault code if wire is broken or heater o/c.
FranzRe: Indesit WIXE127 no heat.
Put some water in the drum and remove wires from heater,fit a mains lead direct to the heater and see if the element goes oc after a few minutes,I have had a couple do this.
- You must be logged in to reply to this topic.