- This topic has 5 replies, 4 voices, and was last updated 17 years, 1 month ago by
.
-
Posts
-
I am being haunted by duff Indesit machines ATM. 😥
Fault code AL02, alledged valve fault. Fills OK washes fine but apparently throws up AL02 half way through cycle. 😕
Heating element not down to earth, no sign of leaks etc, any other possiblities????
Re: Hotpoint DWF70P
pressure switch? blockage, sticky valve, water pressure low, wiring loom, just guessing really
phil
Re: Hotpoint DWF70P
philfish wrote:, just guessing really
phil
Aren’t we all most of the time with this rubbish.
Can’t see any of the above causing the fault at the same time, every time in the cycle though.
Today alone, one 14 month old Indesit with module fault, one 2 year old Ariston W/D with module fault, one Hotpoint WD440 with module fault and this dishwasher with spurious fault. :rolls: 😥
Jim.Re: Hotpoint DWF70P
Dont you just love days like that.I had one like that about three months ago four modules in one day.I think there was a song about that. 😆 I think there should be a thread most Indedsit modules blown up in one day.Record so far 4 can anyone beat it. 😀
Re: Hotpoint DWF70P
Well today has been WMA bearing day. 😀
I used to do three or four of these every week but due to age, cost and the Rubena bearing seal they have died down to one or two each month until this week.
Already done two rear half changes this week , had another two today that have both given the go ahead, only problem is that both Masterpart & my Qualtex agent are now out of stock. 😥
Oh, and back on topic, the dishwasher customer reports that since my visit it has worked perfectly. 😕 :rolls:
Jim.
- You must be logged in to reply to this topic.