ISE 2 flashing 06

Home › Forums › Manufacturer/WP/Insurer Specific Forums › ISE Trade Support Forum › ISE 2 flashing 06

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • March 14, 2009 at 4:23 pm #44232
    iadom
    Moderator

    A bit embarrassing this one. We supplied my daughter with an ISE 2 last April and she has just rung to say its flashing lights that give code 06, motor fault.

    Anyone had any motor problems, machine gets very light use ?

    Jim.

    March 14, 2009 at 4:55 pm #280286
    Penguin45
    Participant

    Re: ISE 2 flashing 06

    Had a couple of triac failures on pcb = runaway motor.

    Chris.

    March 14, 2009 at 5:23 pm #280287
    iadom
    Moderator

    Re: ISE 2 flashing 06

    Apart from the doorlock problems I have had no other faults at all except for one exactly as you describe, going right into spin. Sadly that was also one that was sold to a longstanding friend. 😥

    Apparently there is no motor action at all but I do carry motor & PCB as van stock so all bases should be covered.

    Going to do it in the morning, she lives down in Manchester, just to far to go during the week with the traffic.

    Wonder if I will get a cuppa. 😆

    Jim.

    March 15, 2009 at 6:16 am #280288
    timdowning
    Participant

    Re: ISE 2 flashing 06

    Jim wrote;

    but I do carry motor & PCB as van stock

    I am wanting to carry a few parts for the ISE2’s and was wondering what the cost of the afore mentioned parts were?

    Tim.

    March 15, 2009 at 11:35 am #280289
    iadom
    Moderator

    Re: ISE 2 flashing 06

    iadom wrote: except for one exactly as you describe, going right into spin.

    Wonder if I will get a cuppa. 😆

    And now I have had two as well. 😥 It was the PCB, all sorted and I did get my cuppa. 8)

    Jim.

  • Author
    Posts
Viewing 5 posts - 1 through 5 (of 5 total)
  • You must be logged in to reply to this topic.