Miele W865 Washer

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Miele W865 Washer

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • March 16, 2009 at 3:59 pm #44277
    mike100
    Participant

    Rinse light flashes continous, no motor action and then goes to end.

    Put in new module which incorps brushes still the same.

    Could it be control mod failure as all ok when she did her last wash.

    Mike

    March 16, 2009 at 6:01 pm #280447
    russell555
    Participant

    Re: Miele W865 Washer

    did you “pop” the brushes in once you had secured the module???

    if all the loom is ok to the motor its the lower control module

    March 17, 2009 at 6:46 pm #280448
    mike100
    Participant

    Re: Miele W865 Washer

    Thanks Russell, Yes I made sure the brushes went in ok.
    After that I disconnected the motor and the light was flashing just the same, so I thought it was probably the module.
    Mike

    March 17, 2009 at 7:21 pm #280449
    Seamy
    Participant

    Re: Miele W865 Washer

    It will flash if motor is disconnected, PCB sends down a signal to motor to turn & if it gets no tacho signal back inside a few seconds it shows fault.

    PCBs do cause this fault too, its quite common in them, moisture or steamy athmosphere in rooms where appliance is housed can cause problems, worth checking that too.
    Sometimes a hairdryer on low heat can do the trick.

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.