- This topic has 5 replies, 5 voices, and was last updated 17 years ago by
.
-
Posts
-
model no wfr2868 gb
fault not taking fabric conditionervalves measure ok
there is a strange devise on the pipes between valves and soap draw
similar to a presure switch , i blew through it and it was clear, howerver it has three leads going to itany suggestions appreciated
Re: bosch thingumybob
We commonly replace soap box top (outer casing drawer top or whatever Bosch’s description is!).
Re: bosch thingumybob
delta01 wrote:there is a strange devise on the pipes between valves and soap draw
It’s a flow meter.
As Kez says the fault is a gunged up dispenser top. So either strip and clean it or replace it. A new one is cheap enough at under £15 (Part No : 480836) 😀
Re: bosch thingumybob
thanks guys
customer was advised to clean underside of soap drawer , but maybe he didnt do it very well
Re: bosch thingumybob
or clean wee holes wer water ment to come out with thin peace metal or plastc and blow clear wi peace o pressure pipe does job for me :rolls:
Re: bosch thingumybob
You need to remove the dispenser top lining.
Remove draw, tilt machine back and lean on worktop 45 angle,
push small screwdriver in edge of soap side,looking up to dispenser roof,
as plastic starts to come out, push larger and longer screw driver further to lever back part down then the centre will come out. be gently it can break.
poking wire and ties in dosnt allways work for long,
- You must be logged in to reply to this topic.