VHD 814 vision

Viewing 8 posts - 1 through 8 (of 8 total)
  • Author
    Posts
  • #44407
    paulbur1234
    Participant

    Hi

    i have a hoover VHD 814 vision hd

    it stops and the 1200 light is flashing on and off timmer saver flashs the same time where could i fid the code if there is one

    thanks

    #280888
    Penguin45
    Participant

    Re: VHD 814 vision

    Count the number of flashes over a 15 second period, ie – 1-2-3-4-pause-repeat.

    Penguin45.

    #280889
    paulbur1234
    Participant

    Re: VHD 814 vision

    Hi thanks for reply

    3 flashes then stop
    3 flashes then stop
    3 flashes then stop
    3 flashes then stop

    and keeps repeating that

    #280890
    smartin
    Participant

    Re: VHD 814 vision

    F03 failed to drain=blocked filter bottom left hand side of machine, but you cant just pull it straight out as there is water left in the machine and it will be on the floor in a few seconds, try and pull machine out tilt machine back so you can get a bowl under filter and slowly empty water out into it.

    #280891
    paulbur1234
    Participant

    Re: VHD 814 vision

    Hi

    😳 should have said i have purchased a new drain pump and fitted it and the same error comes up checked pipes and there dont seem to be any blockage.

    at the moment i am washing clothes the washing machine stops then i have to drain water then i can put it on spin.do i need to clear the code? or is there somthing eles im missing 😥

    #280892
    helo_75
    Participant

    is there 2 pumps on that machine?

    some production models had 2

    #280893
    paulbur1234
    Participant

    Re: VHD 814 vision

    not realy sure will try a think i did see somthing when i turned on side
    will have to check again

    #280894
    paulbur1234
    Participant

    Re: VHD 814 vision

    your right there is another pump and i have just found a coin in there hope its that, doing another wash

    thanks a lot for your help 😀

Viewing 8 posts - 1 through 8 (of 8 total)
  • You must be logged in to reply to this topic.