Hygena cooker hood APP 2410 – switch PCB

Home › Forums › Public Support Forums › Help And Support › Cooker And Oven Forum › Hygena cooker hood APP 2410 – switch PCB

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • March 30, 2009 at 2:06 pm #44628
    NeilM
    Participant

    Having checked the forum and found others with the same problematic switch, I was on the point of ordering when I saw the note about soldering.
    To save dismantling more than I have to, can someone tell me if the switch cable is easy to detach from the fan motor end so the board can be soldered at a bench?

    While my soldering skills are probably adequate, having had the board out, I really don’t fancy trying to solder connections with the board in midair while I’m standing at the cooker 🙂

    Thanks in advance.
    Neil

    April 2, 2009 at 5:24 pm #281676
    NeilM
    Participant

    Re: Hygena cooker hood APP 2410 – switch PCB

    Having read again the guidance notes, I appreciate why I did not get a reply 🙂

    Basically I was asking too much of you. I appreciate and understand your caution, since you have no way of knowing how able I am. However, we have managed to replace the switch panel (bought from you – good price, excellent fast service) and the extractor is working once more.

    Thanks again. : :tup:

    April 6, 2009 at 8:08 pm #281677
    karv
    Participant

    Re: Hygena cooker hood APP 2410 – switch PCB

    soldering in air is the easy option i use to put silver knobs back on and hold it from other side back into the the holes at front to hold it depending on model , some people use to have some clips to hold it in place while hanging down. if u doing while hanging where some goggles it can spit

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.