- This topic has 4 replies, 2 voices, and was last updated 17 years ago by
.
-
Posts
-
Not found this fault in the search so hopefully someone here can help, this machine runs though the test sequence with no issue, no alarm/error code at all but what’s happening is that on a 40 colored economy wash it just sits there heating, doesn’t go above temp just reheats when the water temp drops however the machine works fine on a cold wool wash or a 30 temp wash, haven’t yet tried a 90 temp wash though. any ideas?.
David
Re: zanussi zwf1220w
dpr1974 wrote:any ideas?.
As a rule if no errors show up chances are the programme module is at fault?
I’m assuming that the motor runs OK, rinse spin etc?
Re: zanussi zwf1220w
Thanks for the reply Mertin, yes the motor is fine, it doesn’t get as far as the rinse spin on the 40 economy wash but everything is working on every other program.
This is/was going to me my new lend machine, so i decide to check all the programs out between other jobs and the result is that the fault is just with the 40 economy wash, so that would be the board i would assume. I’ve never had to configure a new zanussi board before so i was wondering do these boards get “confused” and would it be worth doing the configuring on the existing board to reset it?David.
Re: zanussi zwf1220w
dpr1974 wrote:would it be worth doing the configuring on the existing board to reset it?
These modules are pre-configured so that isn’t an option. 🙁
- You must be logged in to reply to this topic.