- This topic has 2 replies, 2 voices, and was last updated 17 years ago by
.
-
Posts
-
No error, codes and have reset options etc, but every time it does the final spin out it finishes, then goes back to rinse, and starts over. I have changed the control panel but that had no effect on it. seems too stupid a thing to be controller fault.
Has blue controller and MW panel, any ideas welcome, dont want to throw away what looks like a perfectly good controller otherwiseRe: Smartdrive 051 , keeps on looping rinse cycle
no replies 😥 ? i’m getting the same problem. no error lights flashing when put in diagnostic mode but when i turn the machine off the first 5 lights flash (1-1-1-1-1-0-0-0). this is for a fisher and paykel mw511. any help would be greatly appreciated.
Re: Smartdrive 051 , keeps on looping rinse cycle
this looks like error code 31.
Book says motor controller out of sequence.
refer error code 17.
Action
Turn off s/drv at wall wait 5 seconds. turn back on. Restart
If Fault persists disable auto-restart feature and retest. a new code will appear. ?
Carry out action of new fault ???Never did fix this one, just replaced motor controller. bit short on time is money thing
- You must be logged in to reply to this topic.