- This topic has 2 replies, 2 voices, and was last updated 17 years ago by
.
-
Posts
-
Hi,
we have a Miele w404 Plus machine and it has stopped dosing the fabric conditioner. Had a look and the two “jets” that fill the conditioner section of the tray appear blocked with old conditioner. If I pull it out and remove the top cover will I be able to get access to these to clean them?
All advice gratefully received!
Roger
Re: Miele W404 Plus Not dosing fabric conditioner
Best to pull out the drawer fully, see little catch at back, push this down & remove drawer fully. Take cover off conditioner department in drawer & clean thoroughly removing any gunge or blockage, making sure that water flows though hole & out back of drawer. Take old tootbrush & clean top of dispenser before putting drawer back in.
Fill with conditioner to below full level, try machine on rinse programme again. Do not overdose with conditioner as most are concentrates now.
Re: Miele W404 Plus Not dosing fabric conditioner
Seamy wrote:Best to pull out the drawer fully, see little catch at back, push this down & remove drawer fully. Take cover off conditioner department in drawer & clean thoroughly removing any gunge or blockage, making sure that water flows though hole & out back of drawer. Take old tootbrush & clean top of dispenser before putting drawer back in.
Fill with conditioner to below full level, try machine on rinse programme again. Do not overdose with conditioner as most are concentrates now.
Thanks for that, I have done what you said already but the problem appears to be the jets that fill the conditioner department in the drawer being blocked. Is it best to do these with a toothbrush from within the drawer cavity or by access to the top?
Regards
Roger
- You must be logged in to reply to this topic.