- This topic has 5 replies, 3 voices, and was last updated 17 years ago by
.
-
Posts
-
Hi
Newbie here looking for help. Had some problems with this generic dishwasher last year and I replaced the drainpump which solved it.
Last night we had a 6 hour powercut (not sure if it was mid cycle but dont think so)
Got power back and now with door closed it beeps continually, an intermittent beep. The start lamp flashes twice in a row on a continual basis.
Is it bu**ered or can I reset it or something. Any help much appreciated.Model APDW/2 serial no. 854593715710
Regards
PeteRe: program 2000 APDW/2
Flood protection activated. Base tray under machine is probably full of water. Drain it to reset the machine. If you get a recurrence, you’ll need to find the leak.
To reset the computer, press and hold the start button.
Power off if you intend to investigate this yourself.
Penguin45.
Re: program 2000 APDW/2
Thanks Penguin45
I take it I’ll have to take the dishwasher out as I did when I changed the pump?
Regards
PeteRe: program 2000 APDW/2
Remove lower cover plate and plug. Nice big towel handy and bend down the front edge of the tray is the quickest way.
Penguin45.
Re: program 2000 APDW/2
Penguin45 wrote:Remove lower cover plate and plug. Nice big towel handy and bend down the front edge of the tray is the quickest way.
Penguin45.
Thought it was just me that did that 😆
Re: program 2000 APDW/2
Only just got your reply, thanks. Had a look earlier and instinctivly did what you suggested 💡 It has leaked from somewhere but all connectors I could see were dry.
Unfortunately its still beeping, despite reseting as described. Th e edge of the drain pump terminal block looked fried/melted. Could it have beed shorting due to water rising up in the baseplate and touching it ❓
Is it time for a new dishwasher ❓
Cheers again
Pete
- You must be logged in to reply to this topic.