Beko WMA510W No Spin

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Beko WMA510W No Spin

Viewing 7 posts - 1 through 7 (of 7 total)
  • Author
    Posts
  • April 16, 2009 at 4:35 pm #45038
    johnnyhoz
    Participant

    Suspect the module behind the facia but would like to know I haven’t missed something.
    Carbons only half worn, tacho looks good, wiring to motor checks out OK.
    Symptoms are tumble only, no spin, Set programmer to spin manually but it switches from ready to wash and not spin and just sits there tumbling.

    John

    April 16, 2009 at 10:24 pm #283411
    leavemetogetonwithit
    Participant

    Re: Beko WMA510W No Spin

    Does it drain OK? Does pump operate when spin selected? What about p/sw?
    Mike.

    April 17, 2009 at 6:28 am #283412
    johnnyhoz
    Participant

    Re: Beko WMA510W No Spin

    Thanks for the reply Mike.
    It fills to usual levels, drains normally, it goes through the whole cycle and finishes but doesn’t do a spin.
    Plus when I manually try to do a spin the control doesn’t play ball as explained in my previous post

    John

    April 17, 2009 at 6:56 am #283413
    franz
    Participant

    Re: Beko WMA510W No Spin

    I have had 2 like this lately – just goes to wash no matter where you set prog – turned out to be module.
    Franz

    April 17, 2009 at 7:31 am #283414
    johnnyhoz
    Participant

    Re: Beko WMA510W No Spin

    Cheers Franz

    April 17, 2009 at 8:47 pm #283415
    leavemetogetonwithit
    Participant

    Re: Beko WMA510W No Spin

    From your description, it sounds as if the board may be retaining a memory of a previous setting and not allowing a new programme to be selected until it’s cleared. But how to clear it is the ❓ I sometimes look in the instruction manual at times like that. (We can’t be expected to know all the foibles of operating so many makes and models.)
    Mike.

    April 17, 2009 at 9:17 pm #283416
    lerch
    Participant

    Re: Beko WMA510W No Spin

    How old is the machine ? as when these first came out the boards were abit sensitive and required new updated boards as there would only tumble and not go into a spin.

  • Author
    Posts
Viewing 7 posts - 1 through 7 (of 7 total)
  • You must be logged in to reply to this topic.