- This topic has 9 replies, 2 voices, and was last updated 16 years, 11 months ago by
.
-
Posts
-
dishwasher has power when switched on had comet come out and installed new motor new pcb and new inlet valve. then said they think its the Dishwasher Flow chamber (flow meter). the problem is that water is not filling the dishwasher up ???? any ideas
thanksRe: beko dwd5410
When you switch machine on, the drain pump should acitvate first, then water should come in.
When you switch on do you hear anything happening?.
silverbroom
yes you can her it draning 1st but, then when the water should be going in it doesnt fill at all ???????
Re: beko dwd5410
The drain pump may be running due to the anti flood device being activated.
First , unplug machine from wall socket making it safe, then pull the machine out and tip it back, water may come out. If so then it confirms anti flood had activated. In any case you will have to get an engineer as DIY repairs to dishwashers are not to be recommended.
silverbroom
Re: beko dwd5410
it drained the water. but no water goes in to dishwasher ? doesnt progress any further than that
Re: beko dwd5410
If you had Comet out is the appliance still under guarantee, if so get them to return and sort it out.
silverbroomits already been wrote off under warrenty but i wanted to get it repaired (if i can without major cost.) as i wanted to give it to my disabled sister-in-law.
Re: beko dwd5410
If it is the flow meter as Comet suggest then this is not an expensive part (less than a tenner). Beko call it a “counter”.
Click on “Find an Engineer” see if anyone near you.
silverbroom
- You must be logged in to reply to this topic.