Creda W220VW

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Creda W220VW

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • May 13, 2009 at 11:56 am #45684
    pegasusk7
    Participant

    Anyone come across this fault with a Creda W220VW where the machine never fully completes the spin cycle, starts normally, ramps up through the speeds but then drops to distribution and repeats the whole process indefinitely? Assume PCB module?

    Phil

    May 13, 2009 at 12:04 pm #286588
    Martin
    Participant

    Re: Creda W220VW

    Presumably you refer to a machine that, when testing, the drum is empty?

    Brushes are the main suspect or armature insulation down? And a gunged up air chamber is worth a look? I wouldn’t suspect PCB at this point without the above boxes ticking. 😉

    May 13, 2009 at 12:09 pm #286589
    pegasusk7
    Participant

    Re: Creda W220VW

    Thanks for reply Martin, you assume correctly.

    Motor was the only other thing I could think of and brushes are fine, will check other points.

    Cheers,
    Phil

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.