- This topic has 4 replies, 3 voices, and was last updated 16 years, 10 months ago by
.
-
Posts
-
Hi, my F&P 703 wont fill, have taken hoses off and checked filters but they seem fine, the fill pressure looks really slow.. if i hold the lid just open while filling it looks like it’s not much more than a trickle coming in. Is there a diagnostic procedure i can try to see if there is a problem.
Please HELP!
TIA
blkcrxRe: F&P smartdrive 703 problems
OK i found the diagnostic check instructions and went through with the test, i held down the temp down button while pressing power on, (i didn’t get 2 beeps) all lights lit up for about 2 seconds then it changed to water level high and low lit up. I then pressed spin until slow and hold when lit but it didn’t show any errors.
blkcrx
Re: F&P smartdrive 703 problems
Cold water valve is a 12v proportional fill device and is subject to problems. Good practice is also to check wiring and function of lid switch and out of balance switch – both are subject to corrosion and damp problems.
Penguin45.
Re: F&P smartdrive 703 problems
More than likely inlet valve Cold (Very common fault that they fill slowly)
Part # 426143 ABout $45-$50 AUd
- You must be logged in to reply to this topic.