Beko WMA620 Out of balance Sensor

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Beko WMA620 Out of balance Sensor

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • May 29, 2009 at 5:37 pm #46076
    johnnyhoz
    Participant

    I looked at the above today which will only spin with an empty drum.
    Checked carbons, wiring to motor, security of tacho, wiring to and from control board all looks ok
    Suspect the out of balance sensor which I believe is part of the control board, can the sensor be replaced or does it mean a new board ?

    John

    May 29, 2009 at 6:32 pm #288147
    boselecta
    Participant

    hi
    These machines have a very sensitive out of balance, probably the obvious but have you tried spinning the machine with varied loads, very full load etc.
    Else I would go for PCB.

    May 29, 2009 at 7:50 pm #288148
    chris211
    Participant

    Re: Beko WMA620 Out of balance Sensor

    it is nearly always the pcb on these machines i would also remove the eco ball as well, they have been playing up on these machines as well

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.