- This topic has 3 replies, 2 voices, and was last updated 16 years, 9 months ago by
.
Viewing 4 posts - 1 through 4 (of 4 total)
-
Posts
-
Hi, I am having a problem with identifying a fault with this dishwasher.
It will fill – start washing – then bomb out draining with lights 1 & 4 flashing and light 5 lit.
Looked in the error codes but cant see this combination listed.
Any advice would be very much appreciated.Martin.
Re: Smeg DF614BE 1 + 4 flashing
possible overfill fault, machine continues to fill after circ pump starts and should cut out after 30 secs or so. Had a few of these ignoring the pressure switch and continues to fill until anti flood cuts in. The bad news is that its a glitch on the pcb-not cheap to put right. Take the side panel off and watch it fill to prove.
Viewing 4 posts - 1 through 4 (of 4 total)
- You must be logged in to reply to this topic.