Zanussi FJ1354S 91451283000

Home › Forums › Trade Technical & Spare Parts Forums › Trade Spare Parts › Zanussi FJ1354S 91451283000

Viewing 8 posts - 1 through 8 (of 8 total)
  • Author
    Posts
  • July 15, 2009 at 5:47 pm #47100
    johnnyj
    Participant

    Can anybody help me with part n/o’s for a back half and drum support, i have checked connect and qualtex but there is a note to check tds to find corret spider required can anybody helpp cheers Johnny j

    July 15, 2009 at 6:26 pm #292309
    boselecta
    Participant

    50239965002
    drum support shaft
    344703012
    bearing kit

    Cant believe you want the rear tub, becomes not viable?

    July 15, 2009 at 6:31 pm #292310
    boselecta
    Participant

    1242812327
    tub rear

    July 15, 2009 at 7:34 pm #292311
    johnnyj
    Participant

    Re: Zanussi FJ1354S 91451283000

    Does the drum support come of easily enough is it screwed on like the wma’s and need drilled out, i dont want to order the bits up and be stuffted becuase the screws wont come out JJ

    July 15, 2009 at 9:11 pm #292312
    leavemetogetonwithit
    Participant

    Re: Zanussi FJ1354S 91451283000

    10mm hexagonal headed bolts. You need a good quality socket which is not worn or chamfered because the head is quite shallow and if you round it off you get an extra ten minutes work to do minimum. But they come out much easier than those B*{e5d1b7155a01ef1f3b9c9968eaba33524ee81600d00d4be2b4d93ac2e58cec2d}$:/d WMA bolts.
    Mike.

    July 15, 2009 at 9:12 pm #292313
    Penguin45
    Participant

    Re: Zanussi FJ1354S 91451283000

    Give ’em a belt with the hammer first.

    Chris.

    July 15, 2009 at 9:17 pm #292314
    leavemetogetonwithit
    Participant

    Re: Zanussi FJ1354S 91451283000

    And go prepared for the countersunk pulley bolt with torx (IIRC) head. Give that a tangential tap with a centre punch.
    Mike.

    July 15, 2009 at 9:19 pm #292315
    johnnyj
    Participant

    Re: Zanussi FJ1354S 91451283000

    Thats great guys, cust has given me the go ahead if under £200 i didnt want to order then be lumbered with the bits because i needed an inner drum, thanks for all your help JJ

  • Author
    Posts
Viewing 8 posts - 1 through 8 (of 8 total)
  • You must be logged in to reply to this topic.