Bosch SGV53EO3GB/50

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Bosch SGV53EO3GB/50

Viewing 6 posts - 1 through 6 (of 6 total)
  • Author
    Posts
  • July 22, 2009 at 9:27 am #47260
    WhiteVanMan1
    Participant

    Machine will fill and empty, but I am unable to programme as all led’s are lit at half light, and module will not respond. Any ideas please? Cheers. Steve.

    July 22, 2009 at 12:41 pm #292876
    Martin
    Participant

    Re: Bosch SGV53EO3GB/50

    It does sound like a close look at the PCB is advisable. They are prone to the usual burnt relay terminals and also the main transformer on the board can play up. Especially if they don’t switch the machine off at the end of each cycle but leave in powered up all the time which bu&&ers the tranny. 😉

    July 22, 2009 at 1:42 pm #292877
    WhiteVanMan1
    Participant

    Re: Bosch SGV53EO3GB/50

    I have checked the module, and it all looks fine. I have been to hundreds of these machines over the years, but can’t never remember one behaving like this. It looks like I’ll be taking a chance on the module, and risk carrying yet another part that I will likely never use hehe. That’s life. Cheers for the reply. Steve.

    July 22, 2009 at 8:24 pm #292878
    subs
    Participant

    Re: Bosch SGV53EO3GB/50

    Who’s been buggering tranny’s?

    Sorry couldn’t resist it!

    Subs

    July 23, 2009 at 9:54 am #292879
    WhiteVanMan1
    Participant

    Re: Bosch SGV53EO3GB/50

    hehe, ta for that. Steve

    July 24, 2009 at 8:56 am #292880
    whiskeyjack6058
    Participant

    Re: Bosch SGV53EO3GB/50

    I would send the module in to QER and get them to test it. It doesnt cost much and could save you money in the long run..
    regards,
    Rob.

  • Author
    Posts
Viewing 6 posts - 1 through 6 (of 6 total)
  • You must be logged in to reply to this topic.