neff washer dryer

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › neff washer dryer

Viewing 6 posts - 1 through 6 (of 6 total)
  • Author
    Posts
  • July 27, 2009 at 3:57 pm #47362
    wilf
    Participant

    going to look later in the week showing E06 any ideas before I go?

    wilf

    July 27, 2009 at 4:07 pm #293238
    Martin
    Participant

    Re: neff washer dryer

    wilf wrote:going to look later in the week showing E06 any ideas before I go?

    GOLDEN RULE = MODEL NUMBER BEST GIVEN WHEN ASKING TECH QUESTIONS

    But if it’s the later Smeggy rubbish made machine then it’s either the a drain problem OR (and best worth checking first) gunge up the pressure switch/air bell.

    Mind how you go now! 8)

    July 27, 2009 at 4:41 pm #293239
    nomadPaul
    Participant

    If the appliance number starts with a V then the model is a Smeg machine , as Martin suggested –

    E06 , in my experience , has normally been caused by a blockage at the drum end of the pressure switch hose……and it can be very difficult to get to. I have succeeded clearing this prob in the past by forcing hot water down the pressure hose from the top.
    The machine may need some decent service washes/descaling after to help re-occurence of the fault .

    July 28, 2009 at 7:19 am #293240
    wilf
    Participant

    Re: neff washer dryer

    thanks sorry customer didnt have model number I’ll let you know how I get on

    wilf

    July 28, 2009 at 1:47 pm #293241
    wilf
    Participant

    Re: neff washer dryer

    thanks for the help it was a smeg
    a hair grip stuck in the pump I also took the front off to check the air chamber…………..what a **** place to put it behind the weight!!!!!! the air hose blew through clear so I didt go any further, like trying to remove the weight (does that open the tub?) :rolls:

    thanks again

    wilf

    July 28, 2009 at 3:29 pm #293242
    Martin
    Participant

    Re: neff washer dryer

    wilf wrote:like trying to remove the weight (does that open the tub?) :rolls:

    The weight is attached to the tub front plate via the usual barrel type clamp….. 🙁

    Did you suss the model number in the end by the way? 😉

  • Author
    Posts
Viewing 6 posts - 1 through 6 (of 6 total)
  • You must be logged in to reply to this topic.