Diplomat select 610 fan and light

Home › Forums › Public Support Forums › Help And Support › Cooker And Oven Forum › Diplomat select 610 fan and light

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • August 11, 2009 at 11:14 am #47715
    Twistedpro
    Participant

    Hi i have just moved into my new house and tried my oven for the first time. I dont have a manual for my oven. However when i turn it on the element in the oven element heats up but the fan does not come on or the internal light.

    I have struggled to see the product code and i cant seem to move it out to look on top, its a single fan assisted oven with a single knob and a timer, i think its around 4yrs oldish

    Is it possible that the light and fan are on the same circuit and a fuse has blown or is it more likely that they are broken. If both are broken would i be better getting a replacement or getting it repaired?

    If i got a new one which model would people reccommend?

    Thanks for the help

    August 11, 2009 at 8:30 pm #294343
    karv
    Participant

    Re: Diplomat select 610 fan and light

    hi most likely the light bulb has just gone and your fan motor has seized . fan motors were common problems where they would get noisey or stuck, that would be my first guess , i use to just try to flick them a few times to see if there was any pull on fan blade.

    August 11, 2009 at 11:02 pm #294344
    Penguin45
    Participant

    Re: Diplomat select 610 fan and light

    If it needs parts, you’d better read THIS.

    Penguin45.

    August 12, 2009 at 1:36 pm #294345
    Twistedpro
    Participant

    Re: Diplomat select 610 fan and light

    If the fan does need replacing is this possible to do yourself or is it a job for an engineer?.

    I will try and get the proper model code for the oven when i can move it out

    August 12, 2009 at 2:49 pm #294346
    kwatt
    Keymaster

    Re: Diplomat select 610 fan and light

    Twistedpro wrote:If the fan does need replacing is this possible to do yourself or is it a job for an engineer?.

    It’s possible but you will usually have to strip off panels. We’d need the model number to tell you for sure.

    K.

  • Author
    Posts
Viewing 5 posts - 1 through 5 (of 5 total)
  • You must be logged in to reply to this topic.