neff H7871N0GB03

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › neff H7871N0GB03

Viewing 6 posts - 1 through 6 (of 6 total)
  • Author
    Posts
  • August 19, 2009 at 12:02 pm #47921
    SWERV
    Participant

    Hi, I was wondering if anyone has had to replace one of the atcuators on one of these machines? the reason being is, I went to one today and fitted a power module , when I went to test it, the machine started on microwave, then after about 3 seconds there was a loud bang. One of the tracks had blown on the pcb and on close inspection there was a burn mark on the actuator, that led from the blown track on the pcb.I’ve checked the rest of the mchine over and all appears ok. Just never had this fault before.
    Cheers
    Merv

    August 19, 2009 at 12:23 pm #295003
    SimonCD
    Participant

    Re: neff H7871N0GB03

    I have had the very same fault on one that came into our shop, the actuator uses the same PTC device that most interlocks now use, the type that short out when they fail. expensive!

    August 19, 2009 at 1:20 pm #295004
    SWERV
    Participant

    Re: neff H7871N0GB03

    Thanks Simon, thought I was going mad. It wasn’t the same fault which caused the original board to go. I have repaired the track on the new pcb, so when I fit the actuator I’m hoping that will sort it.
    Regards
    Merv

    August 19, 2009 at 4:29 pm #295005
    nomadPaul
    Participant

    Merv , a faulty actuator can cause massive probs blowing tracks/relays on the main board. I’ve had it where the burnt out area has caused the display module to burn out as well !!! Very expensive repair !

    August 19, 2009 at 4:32 pm #295006
    superfix
    Participant

    Re: neff H7871N0GB03

    I’ve had them take out main relay board and BOTH display boards…. very, very expensive.

    I’d be surprised if re-soldering the track will sort it, but hey you might just get luck 😉

    August 19, 2009 at 5:55 pm #295007
    SWERV
    Participant

    Re: neff H7871N0GB03

    Thanks for the replies,fingers crossed about the board.Amazing, I’ve repaired quite a few of these, but it’s the first time I’ve come across this. Oh well, we live and learn.
    Thanks for your help.
    Merv

  • Author
    Posts
Viewing 6 posts - 1 through 6 (of 6 total)
  • You must be logged in to reply to this topic.