F&P GW609NZ fault

Home › Forums › Public Support Forums › International Forums › Australasian Appliance Forum › F&P GW609NZ fault

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • August 20, 2009 at 3:57 am #47946
    sikastag
    Participant

    Start off by saying, Great forum with lots of helpfull people.
    Hope some one can point me in the right direction…

    Story goes…
    Machine was working up intill the rinse cycle where it would not rinse and turn off. Later on I could turn on and advance to spin.
    Waste pump would pump and drum would start spinning slow then when speed went to increase, would cut out and turn off and machine was inoprotive for some time. On the odd ocasion it would compete a spin cycle an hr later .

    Got a 2nd hand main board (not button/ LED board) and fitted.

    Now I have this fault…

    Plug power in.
    All LEDS light up.
    Faults with 4th LED(short wash) and 1st LED (Spin) lit and beeping.
    press power to turn off.
    hold Temp down and Power buttons to access Service mode.
    Press spin speed up till holld + Slow LED’s on.
    No LEDS on top row are on.
    Only other LED lit is the Low water level light?

    Please help. My wife is threaterning me to go to the landramat. 🙁

    August 21, 2009 at 12:01 am #295075
    Penguin45
    Participant

    Re: F&P GW609NZ fault

    No real idea here – the obvious conclusion is that the boards are not interchangeable.

    Penguin45.

    August 21, 2009 at 6:34 am #295076
    bigsmokepiker
    Moderator

    Re: F&P GW609NZ fault

    your intial problem from the start seems like a faulty pump (Pump overheats and as it is part of the power circuit the machines shuts dwon)
    Pump cools down & overload resets thus machine will function again.
    I would be putting your original Board back in & inspecting pump operation
    IE is the pump getting hot .

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.