Bosch KGU 3201 removal LED panel to replace PCB

Home › Forums › Public Support Forums › Help And Support › Fridge And Freezer Forum › Bosch KGU 3201 removal LED panel to replace PCB

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • August 23, 2009 at 4:35 pm #48012
    n2n-man
    Participant

    HI there,

    I am having a bot of difficulty removing the top pnale in order to replace the PCB. I have undown the 2 screws underneath the panel but uit wont budge, any ideas?

    The top of the fridge was covered in grime, I removed most of this and can’t see any hidden screws here as well

    Thanks

    August 23, 2009 at 5:25 pm #295286
    nomadPaul
    Participant

    These normaly just ‘clip’ into the top section so you should be able to carefully pull the panel ( or lever it ) forward from the top once you’ve removed the bottom 2 screws . Don’t think there’s any hidden screws anywhere else .

    August 23, 2009 at 6:50 pm #295287
    n2n-man
    Participant

    Re: Bosch KGU 3201 removal LED panel to replace PCB

    Thanks for that

    Managed to finally remove the cover, have borken a couple of the plastic clips on the top in the process 🙁

    The FF had died earler today when we lost power to the house, removed the PCB to find that a capacitor has fried, I have an old PCB with the E2 error problem and plugging this in, bought the FF back to life.

    As am unable to find out what size/type capacitor this is , looked up the number on the ‘working’ board and this reads K509u. Its a blue coloured flat small circular cap, any ideas what this could be?

    I dont want to remove the cap from the working PCB and then be left with two duds if you see what am mean

    Thanks

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.