- This topic has 4 replies, 2 voices, and was last updated 16 years, 7 months ago by
.
-
Posts
-
Hi Everybody,
I am new to the forum and can do with your help. The dishwasher gets stuck partway into the wash cycle and the water does not heat up. I have searched and read many posts in this forum over the last couple of days and suspect that the thermostat may have tripped and need resetting.
The dishwasher’s product number is 8511 710 15002 and the serial number is 99 9843 059925. It is a built-in unit and fitted nice and neatly between kitchen units. My question is does this model have a thermostat reset switch? If so, where is it located and how does one get access to it.
Your advice would be most appreciated.
Re: Whirlpool ADG710 WH/2 Stuck in Cycle
if it has a reset it wll be on the thermostat under the bottom of the dishwasher,it will have a red button and will be near the edge of the dishwasher normally at the lef hand side.
you could see it if you take of the front panel,you must take out the plug first.
if it has a red button reset if yu push it it will make a pronounced click if it needs reset.Re: Whirlpool ADG710 WH/2 Stuck in Cycle
Taken the front panel off. Looked everywhere but cannot see any red button.
Does anybody know wheather this model has a thermostat reset button?
Re: Whirlpool ADG710 WH/2 Stuck in Cycle
i am sur it has a resetable thermostat if the heater is visible in the bas of the dishwasher the thermostat is visible under the heater it is round chrome, under the base will be a black plastic thermostat with a red button in the middle.
- You must be logged in to reply to this topic.