- This topic has 2 replies, 2 voices, and was last updated 16 years, 7 months ago by
.
-
Posts
-
Strange fault.
Fills, pre wash drawer,main wash drawer then both again. Stops, no motor action then 2 second burst on pump, then nothing and door lock opens. Will spin ok. Checked p/sw, element, took brushes out, lots on them and when I put them back it worked ok for one wash and then reverted as above. Could the brushes cause this? or is it the pcb?
Any help welcome.
RobRe: ZAN ZWF1021W…. 914205200(04)
Megger all components individually, I’d say. These Lux boards don’t like damp/low ins.. take hairdryer or WD40 to motor. Also check them all as being within expected ranges of dc resistance. After that, wiggle some wires, and finally look for dry joints on board. It’s worth it if it saves investing in a board you may end up not using. Oh, hang on a minute, that’s an ewm1000 board? EMW then. Or try replacing the 12v relays. But damp is first thing.
Mike.
- You must be logged in to reply to this topic.