- This topic has 1 reply, 2 voices, and was last updated 16 years, 8 months ago by
.
-
Posts
-
I wonder if anyone can help out here?
DWF 410 dishwasher, just before end of cycle (Drying mode) front panel starts beeping randomly while displaying 11 minutes.
Open and close the door (dishes clean and dry and hot from drying cycle). Random beeping stops, but cycle will not restart and stuck at 11mins. Simultaneous pressing of 1st two programme buttons will not reset it.
Font panel now displays power light, left most programme light and 11 mins remaining. No buttons react to being pressed apart from pressing and holding leftmost programme buttons which cause timer display to reset but once released timer returns to 11mins.
Powering machine on and off from front panel button and wall socket does not resolve the fault.
Brief inspection of control boards shows no obvious water/moisture damage.
Must fix fast before wife blows a fuse. Unfortunately her reset buttons not working either 😉
Re: Smeg DWF 410 Front Panel Buttons not working
A read of THIS ARTICLE is perhaps a good starting point.
The problem you are describing is not “logical”, which always points to the pcb and corruption issues on a SMEG.
Stay safe, power off before investigating.
Penguin45.
- You must be logged in to reply to this topic.