Tricity Bendix DH909 no finishing

Home › Forums › Public Support Forums › Help And Support › Dishwasher Help Forum › Tricity Bendix DH909 no finishing

Viewing 7 posts - 1 through 7 (of 7 total)
  • Author
    Posts
  • September 27, 2009 at 10:15 am #48881
    tarty
    Participant

    Hi,
    I have got a Tricity Bendix DH909 Dish Wash with a fault
    It runs through all the cycles without a problem, but when it comes to the drying cycle at the end, it will not switch off

    i left it for 2 hours the other day and it wont stop.

    Cheers in advance

    September 28, 2009 at 12:26 am #298047
    Penguin45
    Participant

    Re: Tricity Bendix DH909 no finishing

    No such model – please re-check.

    Penguin45.

    September 28, 2009 at 4:09 pm #298048
    TheSpinDoctor
    Participant

    Re: Tricity Bendix DH909 no finishing

    Do you mean DH090 perhaps. The product number beginning 911…… best identifies the product.

    September 28, 2009 at 9:07 pm #298049
    tarty
    Participant

    Re: Tricity Bendix DH909 no finishing

    yeah thats the one.DH 090

    September 29, 2009 at 4:18 pm #298050
    TheSpinDoctor
    Participant

    Re: Tricity Bendix DH909 no finishing

    Remove the filter & there is a clear-ish plastic dome held in by a screw. Undo it, remove the dome & take out the syphon tubes. Clean thoroughly as best you can, reassemble & test.

    September 29, 2009 at 5:23 pm #298051
    tarty
    Participant

    Re: Tricity Bendix DH909 no finishing

    sorted that now, but it over filled and cut out, how do you re set the magnet piston thing without taking it apart?
    Cheers

    September 29, 2009 at 5:44 pm #298052
    TheSpinDoctor
    Participant

    Re: Tricity Bendix DH909 no finishing

    Isolate appliance from mains electric supply, turn off water, disconnect inlet & outlet hoses, put down floor protection, lay appliance on its back, take off U shaped tube, clear through it & sump spouts & refit, note pressure hoses location, remove & blow down them & refit where they came.

    re install & test.

  • Author
    Posts
Viewing 7 posts - 1 through 7 (of 7 total)
  • You must be logged in to reply to this topic.